ISRO Scientist or Engineer Electronics 2014
For the following questions answer them individually
ISRO Scientist or Engineer Electronics 2014 - Question 61
What is the turns ratio of the transformer needed to match a 1 kΩ source resistance to a 50 Ω load?
ISRO Scientist or Engineer Electronics 2014 - Question 62
A satellite communication link has both uplink and downlink $$\frac{C}{N_o}$$, of 50dB-Hz. What would be overall link $$\frac{C}{N_o}$$?
ISRO Scientist or Engineer Electronics 2014 - Question 63
Determine polarization loss factor for a circularly polarized signal upon reception by linearly polarized antenna
ISRO Scientist or Engineer Electronics 2014 - Question 64
Which instruction of 8051 microcontroller is used for reading data from code memory?
ISRO Scientist or Engineer Electronics 2014 - Question 65
If frequency is decreased 4 times, then skin depth of an Electromagnetic wave inside a conductor will be :
ISRO Scientist or Engineer Electronics 2014 - Question 66
In the circuit shown below, the current through 10 Ω resistor is :
ISRO Scientist or Engineer Electronics 2014 - Question 67
If two tones $$f_1$$ and $$f_2$$ are amplified by a non-linear amplifier, which frequency components would be present in output?
ISRO Scientist or Engineer Electronics 2014 - Question 68
When a sinusoidal voltage wave drives a Schmitt Trigger, the output is a:
ISRO Scientist or Engineer Electronics 2014 - Question 69
What will be content of Stack Pointer if following assembly code of 8051 microcontroller is executed immediately after reset?
PUSH 00h
POP OIh
POP 02h
ISRO Scientist or Engineer Electronics 2014 - Question 70
Consider the sampling of the band-pass signal, whose spectrum is as shown below. What minimum sampling frequency would you use from the options given below, so as to avoid aliasing?
