DMRC Electronics Engineering Paper-1 2014

Instructions

For the following questions answer them individually

DMRC Electronics Engineering Paper-1 2014 - Question 51


The line of sight communication requires transmit and receive antenna to face each other. If the transmit antenna is vertically polarized, for the best reception the receive
antenna should be:

DMRC Electronics Engineering Paper-1 2014 - Question 52


A network contains linear resistance and ideal voltage source. If the value of all the resistors are doubled, then the voltage across each resistor is:

DMRC Electronics Engineering Paper-1 2014 - Question 53


Twelve 1 ohm resistances are used as edge to form a cube. The resistance between two diagonally opposite corners of the cube is:

DMRC Electronics Engineering Paper-1 2014 - Question 54


An eight bit digital data 10101100 is fed to an ADC. The reference voltage is +10V. The analog output voltage will be:

DMRC Electronics Engineering Paper-1 2014 - Question 55


A series RLC circuit has a resonant frequency of 1 KHz and a quality factor Q = 100. If each of the R,L and C is doubled from its original value, the new Q of the circuit is:

DMRC Electronics Engineering Paper-1 2014 - Question 56


The input to a coherent detector is DSB-SC signal plus noise. The noise at the detector output is:

DMRC Electronics Engineering Paper-1 2014 - Question 57


Gunn diode is a:

DMRC Electronics Engineering Paper-1 2014 - Question 58


The intrinsic carrier concentration of silicon sample at $$300^\circ K$$ is $$2.5 \times 10^{16} /m^3$$. If after doping, the number of majority carriers is $$5 \times 10^{20} /m^3$$ , the minority carrier density is:

DMRC Electronics Engineering Paper-1 2014 - Question 59


The unit of $$\triangledown \times H$$ is:

DMRC Electronics Engineering Paper-1 2014 - Question 60


A PIN diode is:

cracku

Boost your Prep!

Download App