SSC JE Mechanical Engineering 2015
For the following questions answer them individually
SSC JE Mechanical Engineering 2015 - Question 191
The included angle for the v-belt is usually
SSC JE Mechanical Engineering 2015 - Question 192
In railway axle boxes, the bearing used is
SSC JE Mechanical Engineering 2015 - Question 193
When the sleeve of a Porter governor moves upwards, the governor speed
SSC JE Mechanical Engineering 2015 - Question 194
When the load on engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the
working fluid to the engine is controlled by a
SSC JE Mechanical Engineering 2015 - Question 195
For high speed engines, the cam follower should move with
SSC JE Mechanical Engineering 2015 - Question 196
The minimum required centre distance of two mating spur gears is decided based on
SSC JE Mechanical Engineering 2015 - Question 197
Which of the following bearings can take large thrust loads?
SSC JE Mechanical Engineering 2015 - Question 198
The cotter joint is used to connect two rods which are in
SSC JE Mechanical Engineering 2015 - Question 199
Which of the following statements regarding ‘mitre gears’ is correct?
These are employed for
SSC JE Mechanical Engineering 2015 - Question 200
Regarding journal bearing under film lubrication condition,
which of the following statements is correct?
Frictional resistance is
